Search results for: btn1=reboot

reboot it, I receive the message: SW RESET DFW 2V10.219 CHECK STORAGE NO NEW FW BANKD INVALID BTN1

reboots, which seems to confirm my suspicion: ``` >(new Pin(BTN1)).read(); =true ``` Pressing the button

BTN1 = REBOOT Unfortunately it does not go away no matter what I do. Is there

BTN1 = REBOOT CONNECT ERROR ``` After about 30s the watch reboots by itself an the presents

reboot. No menus, no apps. When you do that (booting with BTN1 held down) can you *then

reboot (long BTN1 reset) then Bangle.getHealthStatus("day").steps resets to 0 Yes, that's expected

reboot (long BTN1 reset) then Bangle.getHealthStatus("day").steps resets to 0 - you have lost your

Rebooting doesn't do anything, except for reloading the bangle to the same screen. (Rebooting by holding the BTN1

BTN1 = REBOOT And nothing will get me past that. Additionally, when selecting the Bangle.js 2 board

Reboot loop: SW RESET DFU 2V10.219 CHECK STORAGE NO NEW FW BANK0 INVALID BTN1 = REBOOT

BTN1 = REBOOT ``` I was then pressing the refresh button in the "nRF toolbox" or "nRF connect

BTN1 = REBOOT ``` No luck placing it directly on top of the phone. Tried it with

reboot by itself. Basically the watch was showing a "Memory" error, I tried long-pressing BTN3 which gave some error I forgot, and holding BTN1

reboot. The screen only shows "BOARD INVALID" and "BTN1 = REBOOT". Is there a way out of this

rebooted when it ran, but usually if something has caused it to fail you can just hold BTN1

BTN1 = Reboot Connect - Waiting solved nothing. Holding any individual button solved nothing. Rebooting using BTN1

BTN1+BTN2 to reboot it, which it did. But something went wrong, and now the watch

reboot and possibly skip boot if still held. Also there is another gotcha with those touch buttons, they are connected to regular gpio as digital input but there is some capacitive touch controller chip between

BTN1+2 for 10 secs (or Espruino hanging) forces a complete reboot, and if Espruino

BTN1 = reboot' So, it appears to be code other than that of the firmware itself

ok I tried the version 2v07 and I am still stuck at booting...BTN1 = reboot

BTN1 = REBOOT each attempt to reboot just brings up this screen, or one with WATCHDOG

BTN1+BTN2 reboot a few times, no luck. Decided to try a compact - which ran for ages

BTN1 to turn Bluetooth off makes things a bit tricky! Even so, I'm not seeing reboots

reboot with BTN1 and BTN2 held down.. on the dfu startup it reads > WATCHDOG