Search results for: btn1=reboot

BTN1 = REBOOT ``` Any ideas of what I might gone wrong? Thanks. P.S. I've tried

BTN1+BTN3 to reboot and it'll pull it in then... I will just code

BTN1+BTN3 to reboot and it'll pull it in then... @FransM yes, wrapping time

BTN1+2 (for about 10 seconds) which should force a reboot to the bootloader and see if that

reboot - pressing BTN1 & BTN2 for 6 seconds. See issues at the end of this file

reboot with BTN1+BTN2 and you'll be able to connect via Bluetooth and upload

reboot and the welcome app reappeared. This happened over and over again. Reboot with BTN1

from in the case where you hard-reboot using BTN1+BTN2, which should be amazingly rare)

reboot (BTN1+BTN2) it'll be lost. If you use the GPS enough outside to get a lock

when I do BTN1-BTN2 then BNT1 it reboots back to the flashing LED app.

reboot the watch (BTN1+BTN2). Again, my date/time vanished and the watch shows (again) the date/time

BTN1* pressed till the watch has **finished** rebooting not to load any code. (If not a standard

BTN1 and power off BTN2 Am able to reset holding both buttons Loaded the following: > ref https://banglejs.com/apps/ Bootloader Settings Battery Level Widget Bluetooth Widget Mixed Clock Pressing BTN3 after disconnect does reboot

Btn1 and Btn2 for six seconds, even though screen is completely dark. 'Rebooting' then rendered

BTN1 + BTN2 until it reboot, and release before the === line is complete), I can see "DfuTarg

still with BTN1 = REBOOT displayed. Try this: When ==== shows, first release BTN1 and than BTN2

exactly as the screen with `DFU Started` doesn't remain still and `BTN1 = REBOOT` doesn't show.

BTN1 is pressed too long and Bangle.js reboots. When ==== shows, just release BTN2 and short

that the watch entered successfully DFU mode? yes, it says something like: ``` DFU STARTED BTN1 = REBOOT ```

If you want to compile and upload the latest version of Espruino yourself -and you

BTN1 was pressed when you hit reset or plugged it in and it went to bootloader mode - just try pressing the RST button again (with the Web IDE disconnected). Have you tried rebooting