Bangle.beep(); not working

You are reading a single comment by @user110973 and its replies. Click here to read the full conversation.

•

Gordon

@user110973 that is extremely strange.

Do you think you could experiment sending the command analogWrite(VIBRATE,0.1,{freq:2000}) with some values other than 0.1? 0.5ish should start the vibration motor turning, but it's possible that in your case the vibration motor is slightly 'sticky' so doesn't wobble at the lower duty cycles (which is what is making the noise).

My Bangle arrive a few days ago and it buzzes but not beep from the API

Did you update the firmware yet? It needs a firmware update before you can switch to the 'beep via Vibrate' mode...

•

user110973 in reply to @Gordon

Hi Gordon,
I made the update of BootLoader and Settings as recommended. The firmware is 2v05. That's the latest, I think.

I tried

analogWrite(VIBRATE,0.1,{freq:2000})
and
analogWrite(VIBRATE,0.5,{freq:2000})

Both work fine. And surprisingly. Bangle.beep() also works now.
Thanks for your support,

Ingo

About

Avatar for user110973 @user110973 started