You are reading a single comment by @Gordon and its replies.
Click here to read the full conversation.
-
Launching without any code did work for me.
Might (might!) be similar to the issue when you can't turn off after updating from older firmware: the watch just restarts for one-two times if you try to turn it off? -
Hmm - that's odd.
Indeed, I might have messed up triggering resetting without loading any code properly?!? It is complicated (if not impossible due to my probable mistake) to reproduce. Let's forget about it. My bad.
This remark is for me: After releasing BTN2, make sure to keep BTN1 pressed till the watch has finished rebooting not to load any code. (If not a standard reboot only will be triggered.)
AkosLukacs
sebi
@Gordon
Hmm - that's odd. Just tried again here with the latest firmwares and it works great. It's implemented at a very low level so no matter what is in flash memory it'll always work.
If you figure out how to reproduce it then please let me know and I'll look into it.