1kHtz?

You are reading a single comment by @Gordon and its replies. Click here to read the full conversation.

•

Gordon

I'm not 100% sure on the highest frequency, but I believe it is over 1MHz.

My guess is that based on Espruino's execution speed, your code might struggle to run at 1KHz.

You can definitely do a bit better with software if you need to (using setInterval and digitalPulse) but for things like PWM using the hardware wherever possible is preferable.

•

user52526 in reply to @Gordon

The reason why I'm not using setInterval is because it would work for LED's but when I tried using it with a toy motor, it would turn on but not off... setTimeout works for the motor and LED's so I've just been using that

In case it's not obvious, lol, I'm super new and just learning as I go.
•

user52526 in reply to @Gordon

I just found this page

http://www.espruino.com/Waveform

which says espruino can only go up to .5KHtz with analogWrite()

About

Avatar for Gordon @Gordon started