You are reading a single comment by @HughB and its replies.
Click here to read the full conversation.
Espruino is a JavaScript interpreter for low-power Microcontrollers. This site is both a support community for Espruino and a place to share what you are working on.
@HughB
Hi there, my bangle had a bit of a meltdown today. I noticed this morning that I could not get into the ActivePedom settings to look at the sensitivity value, just would not go into the settings. Then went to a 3 mile walk with Walkers Watch running GPS / grid ref on and GPS recorder on. When got back could not display a the GPS log from GPS recorder, just came up with a low memory issue in RED. Did a BTN1+BTN2 reboot a few times, no luck. Decided to try a compact - which ran for ages but was NOT interrupted. When it can back it said 'no clock found'. BTN2 would respond and went into TapeLauncher but there appeared to only be about 4 apps (possibly the info files had got lost).
Connected through IDE and could see the App files were all there. There was however a very large file of about 300KB see screenshot. When downloaded it looked like a concatenation of all files. Decided to rebuild my Bangle, using the App Loader, Delate all apps and install defaults. Then installed favourites.
I then tried another Compact which did not end after 10 minutes and reset the watch. This time no apparent issues though.
To be fair I have put my watch through its paces, I have tried almost every App and doing lots of tests and development, manually wrting info files for new apps, getting things wrong etc, so I might have provoked these issues. No necessarily a bad thing to completely reinstall the watch after a week of tinkering :)
Just wondering if there might be an issue with compact on 2.08.167?
1 Attachment