Search results for: #define

define JSVAR_BLOCK_SIZE 4096 > #define JSVAR_BLOCK_SHIFT 12 > #else > #ifdef ESP32 > JsVar *jsVars

define CLOCK 13 #define DATA 11 #define LATCH 10 int dataReceived = 0; /* Wiring: OUT Not connected

define RED_DATA 0 #define BLUE_DATA 1 #define GREEN_DATA 2 int main(void

define SLAVEADDRESS 0x7E* I have read that the address of the PCF8574 adapter can also

define TX_ENABLE_PIN 3 // define the EIA-485 transmit driver pin #define LED_PIN 13 // SoftwareSerial

defined as one smaller than `bufferSizeTX` 17\. ... and bufferSizeTX is defined a few lines above

define SDA PORTA_BIT6 #define SCL PORTA_BIT7 #define uint8_t unsigned char /***************************************/ /*串口初始化及发送*/ /***************************************/   void

define RODATA __attribute__((section(".rodata"))) ##define EXCCAUSE_LOAD_STORE_ERROR 3 ##define EXCCAUSE_UNALIGNED 9 ##define

define CHECK_BIT(var,pos) ((var) & (1<<(pos))) So my guess is it becomes this

define CHECK_BIT(var,pos) ((var) & (1<<(pos)))` So my guess is it becomes this

define variable 0xvalue with var variable= 0xvalue. For example \#define BQ27441_CONTROL_STATUS 0x0000 becomes

define _WORD_ACCESS must be set to zero, maybe because of alignment restrictions on the LX106

define to a variable object. I looked at some existing modules and found an interesting

define DHTPIN 0 //DHT dht(DHTPIN, DHT22); DHT dht(DHTPIN, DHT11); void setup() { Serial.begin(9600); dht.begin

define SYSCLOCK 16000000 #define IR_USE_TIMER2 unsigned int powerOn[] = { 3502, 1750, etc... 0 }; void

define test_width 16 #define test_height 7 static char test_bits[] = { 0x13, 0x00, 0x15

define is used, but I'd be happy if you wanted to turn it into

define i2c_master_wait(x) os_delay_us(x/4) // do{}while(0) ``` When x is under

defined (STM32F401xx) // 84Mhz -#define PLL_N 336 -#define PLL_P 4 +#define PLL_N 84 +#define

define true (1) ^ In file included from /home/poul/Programmer/Espruino/tve/Espruino/src/jsutils.h:24:0, from targets/esp8266/i2c_master.c:34: /home/poul/Programmer/uPython/esp-open-sdk/xtensa-lx106-elf/lib/gcc/xtensa-lx106-elf/4.8.2/include/stdbool.h:34:0: note

define i2c_master_getDC(void) ((GPIO_REG_READ(GPIO_IN_ADDRESS) >> pinSDA) & 1) ``` so I made

define and C back to D Now it compiles without errors attached the version including

define - line was not displayed correct without ```` // insert after last #include extern int os_printf

define i2c_master_getDD(void) ((GPIO_REG_READ(GPIO_IN_ADDRESS) >> pinSCL) & 1) // PB ``` ``` /****************************************************************************** PB * FunctionName

define FLASH_MAX (1024*1024) #define FLASH_MMAP 0x40200000 #define FLASH_PAGE_SHIFT 12 // 4KB #define