-
• #2
I think this is probably an FAQ and in the Quick Start guide, but type
save()
on the left-hand side :)Once done everything is reloaded as it was, but sometimes you want to do stuff when the board powers on, so you need to put it in a function called
onInit()
-
• #3
Thanks, Gordon. I did go through the FAQ's, it's not there. I might have looked through the quick start guide, can't remember, but you're right that it's explained there.
How do I store my code during power-off, and run on every power-up? It seems my code only runs after sending via USB.