flashing espruino on a olimexino-st32

Posted on
  • Documentation on espruino site miss some simple step, so I write them there:

    1) you need to connect to Serial1 on the olimexino. It's the one on the UEXT port.
    2) if you get "Chip replied with a NACK during 0x31 programming failed" during the flash process, retry without -k parameter. It works for me, YMMV.

    I hope it helps.

  • Actually the documentation / information on the site worked with no issues for me.

    I've just connected the USB/TTL thingy to D7/D8 and powered olimexino via the miniUSB port. Then enter perpetual boot mode (BTN1 + RST) and use the ST Flasher.

    I've just flashed the latest 1.65v a few hours ago.

  • @Diegor - thanks for the update... Were you working from:

    On the serial bootloader page it says only to use the -k switch for Espruino boards...

  • Post a reply
    • Bold
    • Italics
    • Link
    • Image
    • List
    • Quote
    • code
    • Preview
About

flashing espruino on a olimexino-st32

Posted by Avatar for Diegor @Diegor

Actions