Ok, you were right, I was using toolbox. I installed nRF connect and followed your instructions. There is nothing else on the watch screen apart from the DFU Start and btn1 = reboot message. I can not see ‘ Dfu Targ’ or anything else that would resemble the Banglejs in the list on nRF Connect at any time.
After a minute or so, the watch reboots with the brief message
SW reset
DFU ZV12
Check storage
No new fm
Booting…
Next I see the bangle js screen, and at the bottom there os an arrow pointing to the right with the word “Bluetooth”
As for your first question, I’m not sure exactly what you mean but I had been wearing the watch continuously until the Bluetooth stopped working and put it aside after that. As I only really use the Bluetooth to upload new apps and update apps, I’m not sure exactly when it stopped working.
Espruino is a JavaScript interpreter for low-power Microcontrollers. This site is both a support community for Espruino and a place to share what you are working on.
Ok, you were right, I was using toolbox. I installed nRF connect and followed your instructions. There is nothing else on the watch screen apart from the DFU Start and btn1 = reboot message. I can not see ‘ Dfu Targ’ or anything else that would resemble the Banglejs in the list on nRF Connect at any time.
After a minute or so, the watch reboots with the brief message
Next I see the bangle js screen, and at the bottom there os an arrow pointing to the right with the word “Bluetooth”
As for your first question, I’m not sure exactly what you mean but I had been wearing the watch continuously until the Bluetooth stopped working and put it aside after that. As I only really use the Bluetooth to upload new apps and update apps, I’m not sure exactly when it stopped working.