[SOLVED] Bangle 2 bricked?

You are reading a single comment by @msdeibel and its replies. Click here to read the full conversation.

•

msdeibel
I bricked my Bangle 2 but still hope there is a way to recover it.

After updating to 2.12.16 the message displaying didn't work for me so I tried to go back to an earlier version and might have had an update error there.

That didn't work out and I got an error. I tried down to version 2.10, all the same.
During the last three days I also tried to get the latest edge builds on in but to no avail.

I get into the DFU Start without problems and am presented with
```
DFU Start
BTN1 = REBOOT
CONNECT
```
I then start the flashing operation, wich goes up to 99% and then hangs, with the watch showing
```
DFU Start
BTN1 = REBOOT
CONNECT
ERROR
```
After about 30s the watch reboots by itself an the presents the following message
```
SW RESET
DFU2V12

CHECK STORAGE
NO NEW FW
BANK0 INVALID
BTN1 = REBOOT
```
Is there any way to get another working FW back onto the Bangle 2 or does it need recycling?

I tried uploading the FW with the IDE Flasher and the nRF Toolbox.

About

Avatar for msdeibel @msdeibel started