You are reading a single comment by @Gordon and its replies.
Click here to read the full conversation.
Espruino is a JavaScript interpreter for low-power Microcontrollers. This site is both a support community for Espruino and a place to share what you are working on.
@Gordon
Hi,
I wouldn't be too concerned about the battery percentage - it's kind of an estimate based on battery voltage, which depends on temperature as well as the calibration value of some resistors - I'd be pretty sure your battery is still fully charged. If you could run
analogRead(D3)when your Bangle is fully charged (but off charge) and tell me the result, I'll update the values so the next firmware reads ok.And sorry about the Beep issue. Yes, It's just software - I just checked it and while I'd made some Bangle.js 2 tweaks there it seems it had some hard-coded pin values that it attempts to use to make a beep sound (left from Bangle.js 1) - when it poked that hardware pin it caused a crash. I'll get a fix in now