You are reading a single comment by @AkosLukacs and its replies.
Click here to read the full conversation.
-
The second pin says "5v", but if you use it with a 3.3v micro, like the MDBT42, you should connect the "5V" pin to 3.3V!
I have something like yours, in center position it is about half of the input voltage (but not exactly, and not the same on X any Y axis...). As you move the joystick, the voltage should go between 0 and 3.3V. Mine goes to 0 and full voltage waaay before reaching the actual endpoints...
AkosLukacs
Gustav
Alright, what values should i be expecting ? will test this when i get home.
Thanks
/G