Espruino
Espruino is a JavaScript interpreter for low-power Microcontrollers. This site is both a support community for Espruino and a place to share what you are working on.
Espruino is a JavaScript interpreter for low-power Microcontrollers. This site is both a support community for Espruino and a place to share what you are working on.
I am conducting a research project using the Bangle2-watch. One of the aims of the project is to estimate the blood pressure from the PPG sensor. However, the research previously conducted on the subject shows that a sampling rate of >125Hz may be required to provide a resonable signal. In the documentation on the HRM its tated that the ppg sensor samples data up 50 Hz. I've searched the forum but without any luck in finding if it is possible to increase the sampling rate beyond 50 Hz. Looking at the documentation on the sensor it seems as if the sensor is capable of sampling up to 1KHz. But as already stated I fail to find any inforrrmatiopn regarding how to change the sampling rate. Any advice?
Cheers!