You are reading a single comment by @DrAzzy and its replies.
Click here to read the full conversation.
Espruino is a JavaScript interpreter for low-power Microcontrollers. This site is both a support community for Espruino and a place to share what you are working on.
@DrAzzy
It should work - the control is just I2C.
Make sure you have the board correctly set for I2C, if the interface board supports more than just I2C. Note that if the board supports interface modes other than just I2C, it doesn't have the pullups installed, so you'll need to include the 10k pullups on SDA and SCL.
That said, I bought one, and couldn't for the life of me make it work. The ones with the I2C-only breakout boards, like the one shown in the picture on the module page, I think, will work without complaint. The one I got, however, had tons of pins on the back, to allow for all interface modes supported by the chip, and I was never able to make it work - couldn't get it to respond in any way, so I don't know if I was doing something wrong, or my screen was just DoA. I lost interest in the problem when I got one of the 3" 128x64 displays with the Digole controller and handed the SSD1306 screen off to a friend.