Puck.js and SIM 800L module unable to initialize after cutting and restoring power

You are reading a single comment by @Gordon and its replies. Click here to read the full conversation.

•

Gordon
```
<- Serial1
Uncaught ATE0 ERROR undefined
-> Bluetooth
=undefined
```
Ok, great - that's good(ish). So the code is running, but it's the SIM900 that isn't responding.

So I guess it's either power, or you need to try with a delay before initialising it.

do you know of any solid liPo's that would be compatible with breadboard

Not specifically. I use LiPos with a JST connector. The JST connectors have a 2mm pitch on them so if you have a socket for one you can poke it into breadboard directly (it's not a very tight fit) or you can actually just solder a bit of 0.1" header onto the end of the socket.

About

Avatar for Gordon @Gordon started