Most recent activity
-
Hi, thanks for your replies.
Unfortunately i plugged the Pico into the USB and that doesn't work either anymore. No LED flash & not recognised by the WEB IDE. Terminal.
I'll send it back to where i bought it for replacement. -
thanks for the reply,
1) connected correctly
2) its a 9v psu and works fine for other applications
3) usb cable is out
4) solid 9v
5) saved correctly, no errors
6)LED1 flashes then my LED2 flash test program runs
7) breadboard, just the pico and the power connector attached- and - pads for the battery connector test fine with continuity connector to the BAT_IN and GND pins.
- and - pads for the battery connector test fine with continuity connector to the BAT_IN and GND pins.
-
My pico board works fine from the USB, but if i put 9v on BAT_IN and ground GND i get nothing (tested running a simple flash LED1 routine).
voltage on the 3.3 pin is only 0.06v when powering from BAT_IN.
Am i doing something wrong or do i have a poorly pico?
Hi Gordon, definitely 9v DC
Im in the UK, bought from Makersify.
Let me know your address and I'll pop it in the post tomorrow.
Cheers, Jon