Bluetooth not working

Posted on
  • Hi,
    My hc-05 isn't working.
    I soldered two pins on each corner, and when I was done, I connected it to a power source.
    It pops up on my mac, and I open the web ide and it also shows up.
    So I connect, and the web ide says connected, but it only shows
    Connected

    and when I type something it doesn't appear on the prompt.
    with picocom, same thing happens, but the > doesn't appear.
    But both says that it is connected.

  • Is your board powered from the Mac's USB? Try powering it from a wall supply or something that isn't connected to a computer.

    When Espruino detects it has a USB connection, it uses that for communications instead of Bluetooth - leaving Bluetooth unresponsive.

    Or if you were to connect via USB as well as Bluetooth and type Serial1.println("Hello") then it might appear on Bluetooth?

  • Post a reply
    • Bold
    • Italics
    • Link
    • Image
    • List
    • Quote
    • code
    • Preview
About

Bluetooth not working

Posted by Avatar for BootySnorkeler @BootySnorkeler

Actions