You are reading a single comment by @user6583 and its replies.
Click here to read the full conversation.
Espruino is a JavaScript interpreter for low-power Microcontrollers. This site is both a support community for Espruino and a place to share what you are working on.
@user6583
Hi,
I was following the "Get started" section and everything was going fine. I was able to connect via usb, disconnect, enter bootloader mode, connect, write the flash, disconnect, press Reset to exit bootloader mode, then reconnect and write scripts to test the LED toggling etc... and then I unplugged the Espruino and when I plug it back in it always has the blue LED pulsing, which I assume is bootloader mode. I can't write code in the console anymore and pressing the Reset button without pressing BTN1 is not forcing the Espruino to exit bootloader mode.
Is there anything else I can do or some settings I need to change? I assume since it was working at one point it hopefully isn't broken, but it's kind of useless right now. Any tips or help would be greatly appreciated.