You are reading a single comment by @DanDyse and its replies.
Click here to read the full conversation.
Espruino is a JavaScript interpreter for low-power Microcontrollers. This site is both a support community for Espruino and a place to share what you are working on.
@DanDyse
I am having a hard time getting this thing into DFU mode. Meanwhile I have connected / disconnected power and D0 many times I don't even know in what state it is now. The device is showing up in nRF Scanner as MDBT42Q.
Just to make sure: do I have to connect all GND to minus of the battery or just one?
This is how I have it now: GND is connected to the upper left pin. D0 is connected to VDD.
I then connect power to VDD and right after that disconnect D0.
That's correct, isn't it?