You are reading a single comment by @gfric and its replies.
Click here to read the full conversation.
Espruino is a JavaScript interpreter for low-power Microcontrollers. This site is both a support community for Espruino and a place to share what you are working on.
@gfric
I put mine on a 3D printer heatbed. At about 83° I was able to pull it open. Please start with 70° and slowly raise it to prevent a fire. Watch youtube videos of a burning smart phone battery - It's dangerous!
So. I dried mine and sealed it back with epoxy. My button is a bit hard to press now and the vibration is dead. 😟 But bluetooth is working and it's water proof now.