You are reading a single comment by @Serj and its replies.
Click here to read the full conversation.
Espruino is a JavaScript interpreter for low-power Microcontrollers. This site is both a support community for Espruino and a place to share what you are working on.
@Serj
My pal craft a DIY strap. Check it out!
A metal pins from a default strap that broke.
https://www.dropbox.com/s/s0jrzg02jxaz2cm/springbar_holder.zip?dl=0
Link to archive with 3d model of the pin holder;
Basic 3d model print options:
3d printer: Ender 3 V2
Nozzle diameter: 0.4 mm
Material - PLA;
Layer height - 0.12 mm;
Bottom layers - 99999;
Top/Bottom pattern - Concentric;
Print speed - 20 mm/s;
Support-Normal;
Overhang angle - 75 deg.;
Build plate adhesion - Skirt;
To get the best quality orient model vertically.
Checkered green canvas have half an inch by square.