Hi everyone, I have been using the Puck for a while now as part of my research and I have run into some very, very weird behavior recently. I am trying to do some tests where I put the Puck in an RF isolation box (Ramsey) so I can isolate the signals coming from it and for some reason it just refuses to work.
If I load a program onto the Puck, it works completely fine until the second I close the lid on the RF box and then it appears to reboot continuously until I open the lid, then it happily goes back to running the program that was in flash memory.
I have attached a video showing this happen. I loaded a program that just blinks the green LED when the button is pressed. The red light is, I believe the Puck rebooting? It keeps doing that indefinitely if I keep it in the box.
Any ideas as to why this might be happening or what I could do to fix it?
Espruino is a JavaScript interpreter for low-power Microcontrollers. This site is both a support community for Espruino and a place to share what you are working on.
Hi everyone, I have been using the Puck for a while now as part of my research and I have run into some very, very weird behavior recently. I am trying to do some tests where I put the Puck in an RF isolation box (Ramsey) so I can isolate the signals coming from it and for some reason it just refuses to work.
If I load a program onto the Puck, it works completely fine until the second I close the lid on the RF box and then it appears to reboot continuously until I open the lid, then it happily goes back to running the program that was in flash memory.
I have attached a video showing this happen. I loaded a program that just blinks the green LED when the button is pressed. The red light is, I believe the Puck rebooting? It keeps doing that indefinitely if I keep it in the box.
Any ideas as to why this might be happening or what I could do to fix it?
1 Attachment