• I just received my puck.js. It connected to the IDE which informed me that an upgrade from 2.10 to 2.12 was available so I tried to install it.

    What happened was:

    1. I took out the battery, pressed the button, plugged the battery in, then released the button
    2. The LED went green
    3. I started the Flasher and paired it
    4. The LED went blue and then the progress bar slowly marched to completion
    5. The LED went red. I waited a minute and a half and then reset the puck.js
    6. After a reset, the LED went red again. The puck.js doesn't show up in Bluetooth devices when I start the IDE, but I can repeat the upgrade attempt and get back to the red LED.

    Any ideas on what to try next??

About