I'm trying to use Espruino on the ESP32 Heltec WiFI Kit 32 Board. But after flashing the board, the board keeps restarting, saying brownout detector was triggered.
Usually when I plug the board in the console would show up and work, but after a few seconds, the brownout detector would get triggered and start boot looping.
Here is a snippet of the serial console output:
E (551) spiram: SPI RAM enabled but initialization failed. Bailing out.
WARNING: check error not implemented yet:0
____ _
| __|___ ___ ___ _ _|_|___ ___
| __|_ -| . | _| | | | | . |
|____|___| _|_| |___|_|_|_|___|
|_| espruino.com
2v10 (c) 2021 G.Williams
Espruino is Open Source. Our work is supported
only by sales of official boards and donations:
http://espruino.com/Donate
>console.log("hello")
hello
=undefined
>2+2
=4
>
Brownout detector was triggered
ets Jun 8 2016 00:22:57
rst:0xc (SW_CPU_RESET),boot:0x17 (SPI_FAST_FLASH_BOOT)
configsip: 0, SPIWP:0xee
clk_drv:0x00,q_drv:0x00,d_drv:0x00,cs0_drv:0x00,hd_drv:0x00,wp_drv:0x00
mode:DIO, clock div:2
load:0x3fff0018,len:4
load:0x3fff001c,len:2668
load:0x40078000,len:7304
load:0x40080000,len:5312
entry 0x40080274
E (551) spiram: SPI RAM enabled but initialization failed. Bailing out.
WARNING: check error not implemented yet:0
____ _
| __|___ ___ ___ _ _|_|___ ___
| __|_ -| . | _| | | | | . |
|____|___| _|_| |___|_|_|_|___|
|_| espruino.com
2v10 (c) 2021 G.Williams
Espruino is Open Source. Our work is supported
only by sales of official boards and donations:
http://espruino.com/Donate
Brownout detector was triggered
ets Jun 8 2016 00:22:57
rst:0xc (SW_CPU_RESET),boot:0x17 (SPI_FAST_FLASH_BOOT)
The thing is I never had this problem before. Previously, I was using Micropython and was able to run the OLED display and connect to a wifi network simultaneously with no power problems. What could be causing this?
Espruino is a JavaScript interpreter for low-power Microcontrollers. This site is both a support community for Espruino and a place to share what you are working on.
I'm trying to use Espruino on the ESP32 Heltec WiFI Kit 32 Board. But after flashing the board, the board keeps restarting, saying brownout detector was triggered.
Usually when I plug the board in the console would show up and work, but after a few seconds, the brownout detector would get triggered and start boot looping.
Here is a snippet of the serial console output:
The thing is I never had this problem before. Previously, I was using Micropython and was able to run the OLED display and connect to a wifi network simultaneously with no power problems. What could be causing this?