Most recent activity
-
Is it possible to disable wifi at boot? And what does espruino do differently that causes wifi to use so much power that it triggers the brownout detector? As I said before, I have used this same setup before with Arduino and Micropython and never had problems with power, even with a high load as I mentioned in my previous reply.
-
I know about those posts, but did you read my post? I have not had any power problem with this board running Micropython and regular Arduino code with the OLED Screen fully on and while connected to a WiFi Access Point. Meanwhile, with Espruino, I flash the firmware, without any of my code running, no displays, no wireless connections, it triggers the brownout detector. Is Espruino really that power-hungry? Just running the Espruino console requires more power than running a bunch of Micropython code, a display, and wifi at the same time?
-
I'm trying to use Espruino on the ESP32 Heltec WiFI Kit 32 Board. But after flashing the board, the board keeps restarting, saying brownout detector was triggered.
Usually when I plug the board in the console would show up and work, but after a few seconds, the brownout detector would get triggered and start boot looping.Here is a snippet of the serial console output:
E (551) spiram: SPI RAM enabled but initialization failed. Bailing out. WARNING: check error not implemented yet:0 ____ _ | __|___ ___ ___ _ _|_|___ ___ | __|_ -| . | _| | | | | . | |____|___| _|_| |___|_|_|_|___| |_| espruino.com 2v10 (c) 2021 G.Williams Espruino is Open Source. Our work is supported only by sales of official boards and donations: http://espruino.com/Donate >console.log("hello") hello =undefined >2+2 =4 > Brownout detector was triggered ets Jun 8 2016 00:22:57 rst:0xc (SW_CPU_RESET),boot:0x17 (SPI_FAST_FLASH_BOOT) configsip: 0, SPIWP:0xee clk_drv:0x00,q_drv:0x00,d_drv:0x00,cs0_drv:0x00,hd_drv:0x00,wp_drv:0x00 mode:DIO, clock div:2 load:0x3fff0018,len:4 load:0x3fff001c,len:2668 load:0x40078000,len:7304 load:0x40080000,len:5312 entry 0x40080274 E (551) spiram: SPI RAM enabled but initialization failed. Bailing out. WARNING: check error not implemented yet:0 ____ _ | __|___ ___ ___ _ _|_|___ ___ | __|_ -| . | _| | | | | . | |____|___| _|_| |___|_|_|_|___| |_| espruino.com 2v10 (c) 2021 G.Williams Espruino is Open Source. Our work is supported only by sales of official boards and donations: http://espruino.com/Donate Brownout detector was triggered ets Jun 8 2016 00:22:57 rst:0xc (SW_CPU_RESET),boot:0x17 (SPI_FAST_FLASH_BOOT)
The thing is I never had this problem before. Previously, I was using Micropython and was able to run the OLED display and connect to a wifi network simultaneously with no power problems. What could be causing this?
jello