You are reading a single comment by @user113493 and its replies.
Click here to read the full conversation.
-
Maybe someone could verify if this step is needed.
No need to verify, it makes no sense. Fortunately you did only half of the damage so it is hopefully harmless. If you would also run
nrfjprog -f NRF52 --memwr 0x10001204 --val 0x00000015you would be exactly where you was - reset pin enabled + device in continuous reset.Maybe just reboot or something else you did helped. Or maybe you also had another issue why it didn't run on battery.
fanoush
@user113493
After --recover the firmware seemed to work only in the jig, not with a battery. So I tried memwr and then it worked fine. Maybe someone could verify if this step is needed.