You are reading a single comment by @gmurphy and its replies.
Click here to read the full conversation.
-
Did you try to put solder on the MDBT42V before actually soldering it on the PCB?
--> https://youtu.be/z68jccvO04k
Did you try to put solder on the MDBT42V before actually soldering it on the PCB?
--> https://youtu.be/z68jccvO04k
Espruino is a JavaScript interpreter for low-power Microcontrollers. This site is both a support community for Espruino and a place to share what you are working on.
Jean-Philippe_Rey
@gmurphy
Despite my first success, over the past 24 hours I've failed at five of them - it could be my PCB design, but regardless of whether I use a hotplate or hot air, I invariably end up either not getting a connection or delidding the MDBT42V. Any tips? Are you using a solder stencil? Very very precisely pasting each pad? Smearing paste on both and heating?