BTN2 not working, even after updating firmware

Takes about 15 seconds to show my clock after starting up. it is black in the meanwhile. after that i can not use BTN2 to get in the menu. Since BLE is turned off, I can not reinstall the default apps or whatever. Tried to update firmware via the iPhone app, nothing changed. Any ideas?

Did you install something other than the default app? It might be there is an issue with one of the clock apps - if you could let me know which one I can see if I can reproduce/fix it here.

However, all you need to do to get it working is: https://www.espruino.com/Bangle.js#resetting-without-loading-any-code

• Long-press BTN1 + BTN2 for about 6 seconds until the screen goes blank
  
• Release BTN2 but keep pressing BTN1 while ==== goes across the screen
  
• Keep holding BTN1 while Bangle.js boots
  
• Release it - you should have the Bangle.js logo, version, and MAC address
  
  

So you go through the bootloader, and as long as it boots with BTN1 held down, it won't load any of your saved code. You can then connect with the App Loader and remove the offending clock app and/or try 'Install Default Apps' which is basically a factory reset.

It worked, thanks! Cant remember exactly cause I didnt use the watch for 6 months since it wasnt working... My favorite apps which I mostly installed are:
Launcer
App Manager
GPS Time
RAM Widget
Bluetooth Widget
About
RPG dice
CPR Assist
Notifications
Timer
Pedometer widget
Vertical watch face
Chrono
Spirit Level
Compass
Battery Level Widget (with percentage)
Hearth Rate Monitor
Torch
Mixed Clock 2
Counter
Bootloader
Settings
BangleRun
Battery Warning

Hope this helps!

Great! Thanks for the list! If you had an older firmware it's possible you hit a problem with the flash filesystem (that is now fixed in 2v08) and that managed to corrupt things.

I had 2v06