Win7 no comport in WEB IDE

You are reading a single comment by @Robin and its replies. Click here to read the full conversation.

•

Vladimir
Hi,
I have not found my case in Troubleshooting. So I'm describing the problem here.
- The Esp WIFI with the same cable works fine with Win10.
- In Win7 I've got the board in Windows Control Panel's 'Devices and Printers' page - 'STMicroelectronics Virtual COM Port (COM8)'. The status is Ok. The IDE reports 'searching ... no ports found'. I tried all different options: reinstalled drivers, reinstalled WEB-ide, reset and cleaned COM ports. No changes.
  Moreover when i Hold down the button, and then plug the board in while keeping it held, I get 'Red and Green light brightly for a fraction of a second, then they start 'pulsing', and sound signal of a connection to PC. But nothing happens on the side of IDE

•

Robin in reply to @Vladimir

Sun 2020.09.19

Hi @Vladimir,

Has this page been referenced?

https://www.espruino.com/Troubleshooting#my-board-doesn-t-appear-as-a-usb-serial-port-in-windows

See heading: 'My board doesn't appear as a USB . . . '
Instructions for pre Windows10

re: ''Red and Green light brightly for a fraction of a second, then they start 'pulsing''

Same link as above, see heading 'Espruino stopped working'
"If you get pulsing Red/Green LEDs, it's because . . . "

For clarification, is the intent to reflash the WiFi, or is it that the WebIDE just is not recognizing the COM port?

About

Avatar for Robin @Robin started