You are reading a single comment by @Gordon and its replies.
Click here to read the full conversation.
Espruino is a JavaScript interpreter for low-power Microcontrollers. This site is both a support community for Espruino and a place to share what you are working on.
@Gordon
I need to do a video on this, but I actually just got around to trying some different things with Piezos and the results are a bit disappointing.
However it seems that if you don't care about the heart rate sensor, you could poke out the little circle in the middle and glue the piezo over that, and it might actually be ok.
Soldering shouldn't be too bad as the pads are quite far away from other components, but you'll still need a proper soldering iron (not a gas powered one, or a massive one you use for stained glass :)