-
Is it feasible to assume that with the experiences gathered there could be Bangle.js ports to other models too?
You think about doing the port yourself for specific watch? Yes, that is possible due to espruino being open source and lot of work done for Bangle. As for same manufacturer the F5 is there in some state done by Gordon (if you can still buy the device ) and then we know the No.1 S10 is SDK11 based and the board design looks very similar to F18 (a bit thinner, missing compass and gps). Then there is DT28 which is even thinner has only two buttons but full touchscreen and we know this one has signed firmware so you need to open it via screws on the back and use SWD. As for other form factors and manufacturers - there is plenty of options, but to reuse stuff done for Bangle so far, you need something with similar display, buttons and also external SPI flash inside for the storage. Fortunately lot of them has such flash (used for storing chinese fonts) but some don't. Anyway it is all doable but needs some time and effort.
You are reading a single comment by @fanoush and its replies.
Click here to read the full conversation.
fanoush
@Gordon:
I know you reverse engineered several watches before deciding for that specific model. The same manufacturer also has watches with a round display. Is it feasible to assume that with the experiences gathered there could be Bangle.js ports to other models too? Or maybe another KS campaign?
Ooops, holding you off of the more important work... ;-)