ESP32 - Disable Wifi and BLE causes infinite reboot

Looks like if I disable BLE and disable Wifi, the ESP32 goes into an infinite reboot loop.

>ESP32.enableBLE(0)
...
// normal reboot
...

>ESP32.enableWifi(0)
Erasing saved code.
Done!
ets Jun  8 2016 00:22:57
rst:0xc (SW_CPU_RESET),boot:0x13 (SPI_FAST_FLASH_BOOT)
configsip: 0, SPIWP:0xee
clk_drv:0x00,q_drv:0x00,d_drv:0x00,cs0_drv:0x00,hd_drv:0x00,wp_drv:0x00
mode:DIO, clock div:2
load:0x3fff0018,len:4
load:0x3fff001c,len:2668
load:0x40078000,len:7304
load:0x40080000,len:5312
entry 0x40080274
E (545) spiram: SPI RAM enabled but initialization failed. Bailing out.
WARNING: Bluetooth is disabled per ESP32.enableBLE(false)
Guru Meditation Error: Core  0 panic'ed (StoreProhibited). Exception was unhandled.
Core 0 register dump:
PC      : 0x400d8b18  PS      : 0x00060b30  A0      : 0x800d915b  A1      : 0x3ffde6c0
A2      : 0x00000001  A3      : 0x00001e78  A4      : 0x00001000  A5      : 0x00000000
A6      : 0x3ffc40cc  A7      : 0x3ffd6934  A8      : 0x00000000  A9      : 0x00000001
A10     : 0x00000000  A11     : 0x0001e780  A12     : 0x00000005  A13     : 0x00000000
A14     : 0x00000000  A15     : 0x0003ffff  SAR     : 0x00000019  EXCCAUSE: 0x0000001d
EXCVADDR: 0x0000000e  LBEG    : 0x4009b418  LEND    : 0x4009b423  LCOUNT  : 0xffffffff
Backtrace: 0x400d8b18:0x3ffde6c0 0x400d9158:0x3ffde6e0 0x400f85e5:0x3ffde700
Rebooting...

// and this goes on...

Only way to recover is to erase + reflash the ESP32.

Tested with 2v01 and 2v04 with two boards:

• Generic ESP32 "dev board" chip reported by esptool: ESP32D0WDQ6 (revision 1)
  
• TTGO Lora32 v2.0 ESP32-PICO-D4 (revision 1)
  
  

Ran into this earlier, just ignored... The Chip running hot on blink sketch thread was the final push to re-test this again.
Can someone else confirm this? Any idea how to fix?