8x8 LED matrix, one column not working?

Hello

I have been playing around with my 8x8 LED matrix and for some reason when I use Espruino my 4th column (from the left) does not work, I know it is not a hardware issue because if I use the matrix with Arduino it works just fine.

SPI1.setup({mosi:D14, sck:D13});
var disp = require("MAX7219").connect(SPI1,D15);
disp.intensity(0);
var arr = [255,255,255,255,255,255,255,255];
disp.raw(arr);

Here is the code I use to test the display, also I'm not sure if the MAX7219 module is the best to use?

My board is the Wemos d1 mini

Thanks

Do you have a link to the actual 8x8 matrix you're using?

Yes, here you go :)

Can you try removing disp.intensity(0); ? I guess that could be doing something strange.

Also, you're sure that the GND pin is connected?

Removing the intensity didn't help and it works just the same with ground connected or disconnected.
Can I somehow check if the ground on the LED matrix is broke? I think I remember that all columns used to work

Testing out the LED matrix (disconnected from MAX7219 driver board) w/ a 5V source and a 470 ...1K Ohm resistor will tell you... and then you do the same with a single LED and the driver board... that will tell you what is broken... or it may just have been a cold soldering point... had those duds when working w/ flip-dots... it just did not want to work, and that's the procedure I used to get to the bottom of the issue.

Haven't been able to test it yet but I was thinking, since it works with an Wemos d1 mini running Arduino code, shouldn't that indicate it's something to do with the software?

Have you tried the arduino code recently as there might be a hardware issue since the last time you tried it?

Got time to test it today and indeed the column of LED's did not light up... So it seems like there is a problem with my LED matrix or the MAX7219 driver board. Also I wanna say thanks for all the help guys! Really appreciate it!

Problem found! Seems like one of the soldering's on the driver board was bad :) thanks for all the help once again!