You are reading a single comment by @Gordon and its replies.
Click here to read the full conversation.
Espruino is a JavaScript interpreter for low-power Microcontrollers. This site is both a support community for Espruino and a place to share what you are working on.
@Gordon
Probably having the logo on there makes it a lot more likely to delaminate anyway since the printer's having to do some quite detailed stuff on the lower layers...
It looks great as-is, but if the case extended over the black bit and edges of the display then not only would it detect the relatively delicate display controller under the black rubber, but you'd have a much bigger area in contact with the printer bed which might help to combat lifting as well?