It turns out you can cut it out on a £150 diode laser engraver. That's what I used for some of the prototype bits (with the slightly less shiny edge). You could 3D print it I guess, but a custom design would be a lot better to avoid printing the different slices.
@MaBe great! OpenSCAD? :) I'll try and send over the SVGs I have - they might help for measurements.
Espruino is a JavaScript interpreter for low-power Microcontrollers. This site is both a support community for Espruino and a place to share what you are working on.
It turns out you can cut it out on a £150 diode laser engraver. That's what I used for some of the prototype bits (with the slightly less shiny edge). You could 3D print it I guess, but a custom design would be a lot better to avoid printing the different slices.
@MaBe great! OpenSCAD? :) I'll try and send over the SVGs I have - they might help for measurements.