...if not, there is always the option of: re-3d-print... ;-).
Do you use ABS for that? ...you can shiny it up by dipping it into Aceton... or expose it to some vapors... it also increased strength incredibly (except you already use filaments w/ carbon fiber).
Unfortunately my 3d printer only supports PLA. I am experimenting with Proto Pasta graphite pla on the bezel connected to the capsense pin on the puck. It works but the main problem seems there isnt a setWatch() for capsense, so I run a constant fast interval.
Espruino is a JavaScript interpreter for low-power Microcontrollers. This site is both a support community for Espruino and a place to share what you are working on.
...if not, there is always the option of: re-3d-print... ;-).
Do you use ABS for that? ...you can shiny it up by dipping it into Aceton... or expose it to some vapors... it also increased strength incredibly (except you already use filaments w/ carbon fiber).