You are reading a single comment by @PressAnyKey and its replies.
Click here to read the full conversation.
Espruino is a JavaScript interpreter for low-power Microcontrollers. This site is both a support community for Espruino and a place to share what you are working on.
@PressAnyKey
Hello.
There is few questions about pl2303 and IDE.
I was successfull flash the firmware to my stm32f103rct6 based board using pl2303 usb converter.
Set the boot0 to 0 and try to connect the board. And nothing happens. IDE wrote only "Disconnected". I try all baud rates. IDE supports PL2303 converter or i must use the board with other converter? Maybe i make a mistake with flashing?
If IDE support this converter and firmware is ok what i need to do to connect this board wiht IDE?
Many thanks.