You are reading a single comment by @BootySnorkeler and its replies.
Click here to read the full conversation.
-
Sun 2017.03.05
@user73202
I've tried a lot of times, everything I found online and what you told me to do. nothing works.
What is meant by "I've tried a lot of times" . . . . "what you told me to do"?
Are you referring to the process of re-flashing or the removal of solder from the bridged solder pads?
Has the solder bridge been removed?
Is it possible that the correct BTN1 is being pressed and held with a tap on RST, but incorrect orientation may have them reversed? http://www.espruino.com/EspruinoBoard
Do the Blu and Red LEDs flash at all after the release of RST? http://www.espruino.com/Troubleshooting
Robin
@BootySnorkeler
Hey,
I've tried a lot of times, everything I found online and what you told me to do.
nothing works.
I hooked up a usb-ttl converter and tried reflashing the firmware, but no luck
same thing with starting bootloader mode; I pressed and held BTN1, then pressed and released RST, but nothing happens.
The red and blue LEDs just glow dimly, and there's nothing I can do.