• I tried with another board : always the same consumption of about 1mA. But if I put all the pins as "output" the consumption is about 500uA... rather higher than your value... Have you an idea ?
    The setup :

    • Pico : 1.4
    • Firmware : from Chrome IDE or from Github 1.85 (no difference)
    • Vcc = 3.7V (GND and VBat)
    • 4 - 5mV on a 10Ohms resistor (400 to 500 uA)
    • 100nF Low ESR on wires to the board

    Thank you for your answer !


Avatar for Gerald @Gerald started