You are reading a single comment by @errantspark and its replies.
Click here to read the full conversation.
Espruino is a JavaScript interpreter for low-power Microcontrollers. This site is both a support community for Espruino and a place to share what you are working on.
@errantspark
I bricked my pico by running f.erasePage(); just like that without any parameters, I can't figure out how to wire it up so I can talk to the serial port, what do I have to do?
I've penciled over the jumper on the back, I need to hold the button to bring that one to 3.3 correct and BOOT1 ends up at ground automatically on the pico?
http://www.espruino.com/Pico <--- it suggests that there's multiple pins connected to USART1? But the wiring diagram implies that I actually have to connect to TX to USB+ and RX to A10?
Have no idea what's going on honestly, just want my pico back : (