I got a new stm32f4discovery board. I followed the quick start and other boards directions and successfully installed espruino on it through st-link utility. When I press the reset button the led right next to it flashes quickly which I read means espruino is properly programmed and running.
Now when I go to the espruino web IDE I can connect to the COM port and then when I try to type in the terminal nothing happens. If I press a key nothing shows up in the line or anything.
Espruino is a JavaScript interpreter for low-power Microcontrollers. This site is both a support community for Espruino and a place to share what you are working on.
I got a new stm32f4discovery board. I followed the quick start and other boards directions and successfully installed espruino on it through st-link utility. When I press the reset button the led right next to it flashes quickly which I read means espruino is properly programmed and running.
Now when I go to the espruino web IDE I can connect to the COM port and then when I try to type in the terminal nothing happens. If I press a key nothing shows up in the line or anything.
Any ideas on whats going wrong?
-Mike