You are reading a single comment by @Gordon and its replies.
Click here to read the full conversation.
Espruino is a JavaScript interpreter for low-power Microcontrollers. This site is both a support community for Espruino and a place to share what you are working on.
@Gordon
I guess the other solution is to use some kind of ribbon cable (which generally have a 0.05" pitch) - however stripping/soldering those is a pain too.
You could also do some serious pin-bending on some 4x2 0.1" pin header, and then solder it onto the end of the board - however that'd be more of a pain to do initially.