Pico and ESP8266

You are reading a single comment by @DrAzzy and its replies. Click here to read the full conversation.

•

DrAzzy

It sounds like there was no communication between espruino and ESP8266. Did you get any errors after you sent the code? Whjat was printed to console?

Blue light should start blinking when it runs the require("ESP8266WiFi").connect(...) line - how is it connected to the Espruino? Are you using the shim? Are you sure all the wires are connected well? Have you installed a 1uf (or more) capacitor next to the ESP8266 (there are pads on the shim for a smd one)? The ESP8266 modules seem to need one to function reliably.

•

cool_acid in reply to @DrAzzy

When I send the sample code I get this error:

Uncaught No 'ready' after AT+RST
 at line 2 col 18
  if (err) throw err;
                  ^
in function "a" called from line 1 col 100
...a("No 'ready' after AT+RST");else return c}
                               ^
in function "d" called from line 1 col 16
{e=void 0;d&&d()}
                ^
in function called from system

I'm using the shim, and I've checked a lot of times that all is connected where it is meant to be. I installed a 10uF cap in the shim.

Pico and ESP8266

About

Espruino