You are reading a single comment by @DrAzzy and its replies.
Click here to read the full conversation.
Espruino is a JavaScript interpreter for low-power Microcontrollers. This site is both a support community for Espruino and a place to share what you are working on.
@DrAzzy
Nice looking board!
Someone puts way more effort into their silkscreen design than I do! (on my boards, you're lucky if the part identifiers (ie, R1, R2, etc) aren't under another part or off the edge of the board).
What I always do is to make as many boards as possible at once, and do one part at a time on each board, then set that aside and do the next one. IC's, resistors and caps first, tall stuff last, so you don't get in your own way. I've never had more than like 4-5 boards being loaded at a time, and those were small boards, but it felt like it would scale decently well. Please tell me you got a stencil for the solder paste. (I would have used 1206 parts, personally, if I knew I was going to hand-load the boards - it looks like you've got the space).