You are reading a single comment by @Gordon and its replies.
Click here to read the full conversation.
Espruino is a JavaScript interpreter for low-power Microcontrollers. This site is both a support community for Espruino and a place to share what you are working on.
@Gordon
I'm getting the new Espruino board revision laid out by Seeed this time (instead of me).
One of the changes is the use of a 4 pin through-hole Micro USB connector (I'm not taking any chances this time!) - however Seeed tell me that they can't position it where it was (if I'm honest I don't really see why).
Instead, they want to move the USB over towards the pin strip, and bring the JST battery connector back over towards the ARM (and where the USB connector was). Does anyone have any problems with this?
Obviously it's a pain if anyone is planning boxes with cutouts - but I'm not sure anyone is, apart from Phenoptix (and theirs could be changed quite easily).