You are reading a single comment by @bigplik and its replies. Click here to read the full conversation.
  • Thanks!

    note that I have made a small correction to the code in order to prevent double launch of the blink sequence if it is already active.

  • cool, I had some counting problem when disconnected and connected board again, everything was working till I didn't use "save()" command and turned board off and back on, or disconnected and connected again, will check how it is going on now ;)

    fdufnews - everything is workin now, even after power of and on again the board,
    very helpful ;)

About

Avatar for bigplik @bigplik started