You are reading a single comment by @Progma and its replies.
Click here to read the full conversation.
Espruino is a JavaScript interpreter for low-power Microcontrollers. This site is both a support community for Espruino and a place to share what you are working on.
@Progma
I'm using a Hall Effect sensor that likes to just switch to an on state and stay there even when the magnet is taken away. I might just need a general knowledge of the sensor as well as a few questions below.
How would I deactivate the sensor every time? like for example, putting the same side of the magnet to the HEs or the opposite side?
Any way to not have it act like a switch?
Thanks!