You are reading a single comment by @d0773d and its replies.
Click here to read the full conversation.
Espruino is a JavaScript interpreter for low-power Microcontrollers. This site is both a support community for Espruino and a place to share what you are working on.
@d0773d
I set up my wifly to auto connect to my access point and connect to my website when data is received at the wifly rx pin. On page 63(not 100% sure) of http://ww1.microchip.com/downloads/en/DeviceDoc/rn-wiflycr-ug-v1.2r.pdf it explains the alternate functionality of GPIO4. I would like to enable the alternate functionality of GPIO4 so the Espruino can monitor if the wifly is connected to the Access Point or not. Even though the manual explains how to achieve changing GPIO4 functionality I am still unsure what the bit code and command I am needing to use. Also, how do I setup a pin on the Espruino to check the status of the GPIO4 pin of the wifly?