Search results for: btn1=reboot

yes, except it only says ``` DFU START BTN1 = REBOOT ``` it doesn't say BL 2v20

BTN1 = REBOOT ``` Bear in mind it will reboot after 30s so if you don't have

BTN1 = REBOOT ``` I have experience with soldering, have a couple of RPIs for potential UART

btn1 = reset ===>’ and the black menu with all the options to factory reset, reboot, restart

BTN1 is mapped to pin D0 https://github.com/espruino/Espruino/blob/master/boards/MDBT42Q.py#L80 However there is also easy but destructive way, you can clear bootloader settings page containing firmware validity flag and checksum making the firmware invalid and then

BTN1 will go into launcher (danger, i wanna disable this) 2. a 1.5s press on BTN1 will go back to the clock (i.e. no security breach) 3. a 10s press will reboot

BTN1" after a discussion in another thread about maintaining the default behaviour of the button. However, at the current time, the button does cause the light to come on, but it does not enter

reboot time for less than 3 seconds or it enters Espruino but avoids running any js code at startup if you hold it longer (test it now :-), if you put watchdog pinging on BTN2 then

BTN1_PININDEX dfu_start = get_btn1_state(); #else ``` but I agree that it is somewhat dangerous. With that one liner in bootloader you enter DFU by `poke32(0x4000051c,1)`, with softdevice enabled it automatically reboots

reboot, with the message: ``` DFU 2v16 BOOTING ... ``` When trying to boot with BTN1 and BTN4

reboot and hold BTN1 and BTN4 while loading, the splash screen won't be loaded

BTN1 for DFV" screen. After a second, it boots to logo again. Have a look: https://www.youtube.com/watch?v=vYRifdvmuQ4 If I press the button, I can sometimes make it enter DFV or stay on the logo

rebooting is enough (E.reboot or holding btn1+2), firmware is in flash not ram so you cannot

btn1=reboot"](https://forum.espruino.com/search/?q=btn1%3Dreboot+sort:date), the top result is a comment in conversation "Bangle2 : Won't boot

Update" right after the Bangle 2 displays these two lines: DFU Start BTN1 = REBOOT Right?

BTN1 reboot until the error message in the DFU app appears and the watch reloads

BTN1 = REBOOT ``` but don't know what to do with it. It would be totally

BTN1=REBOOT ``` and after minute or so it then goes to the same screen as above

reboot back into DFU mode, with the same message (see attached image): ``` SW RESET DFU ZV13 CHECK STORAGE NO NEW FW BANK0 INVALID BTN1

reboot the watch. It is stuck on the display "SW Reset > DFU 2V12 > CHECK STORAGE > NO NEW FM > BANKD INVALID > BTN1

btn1 = reboot message. I can not see ‘ Dfu Targ’ or anything else that would resemble

rebooting the watch into bootloader mode, where it says: ``` DFU START BTN1 = REBOOT ``` It should

BTN1 = REBOOT` press the button down for about 2 seconds and it should jump right

BTN1 for DFU" because it thinks the button is pressed). Also holding the button prevents watchdog kicking (by design, to have a way to reboot

reboot it, I receive the message: SW RESET DFW 2V10.219 CHECK STORAGE NO NEW FW BANKD INVALID BTN1